The break water had to bend in about 6 different ways, but I got there eventually. Probably the hardest parts to build and make were the bases for the amidships gun director towers, there were very few photos of this area I could find and resorted to communicating directly with the museum to get good references.įinally starting to look like a battleship, most of her AA that was added at a later date has yet to be manufactured. This was my first go at the 5inch 38 turret ring, I figured I could sand them down to shape, that was not a terribly good idea as it just ripped off the deck, there were just replaced with disks that are the proper size, 3D print funnels were sourced from Model Monkey. The main battery barbettes were made by laminating plastic and putting it inside the lid of a TET brush which had a roughly similar diameter to what I needed. I had the old set of 3d printed gun houses in fine resin, these would be replaced by a latter dark grey set from Model Monkey The very stern of the kit was rather blunt and I will be the first to admit that it was user error that blunted it, but, I fixed it. To fill in the giant hole in the front where the armored citadel should be I carved the forward fire control tower and citadel from balsa as I didn't feel brave enough to use plastic. Here I have placed the basic superstructure onto the hull, still fairly spartan but it was thrilling to have it look like a battleship on the slip way 5mm styrene sheet and with careful down scaling of the drawings I started to have a superstructure. I apologize about the very grainy first few photos those were taken on a very old phone.Īfter the decision to replace the super structure came the acquisition of several different reference books and asking the museum itself for pictures of hard to see or under represented areas.Įverything was build up out of. The original kit superstructure wasn't terrible but had some clunky details (like gun houses, range finders, AA suite, funnels) and poorly represented areas ( around the bridge and forward funnel) that I wanted to change to be a little more prototypical of the actual ship, some thinking later and it was time to start from a blank slate of. I've been working on this one for a year or so and I'm starting to see the light at the end of tunnel on this essentially scratch build.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |